15kV 630A / 20kV 630A IEC type Tee connector

OEM and ODM are accepted

Summary
Shielding 630A IEC type Tee connector, directly connect to the bushing of switchgear and the wall bushing of cable branch box.provide fully insulated safety circuits for Switch cabinets and cable branch boxes. The tail can be plugged directly with insulating plugs, but also extend the connection after the connection
Head or rear connector with surge arrester.
Through 630A prefabricated joints to achieve single-phase or three-phase insulated cables and transformers, switchgear, branch boxes and other equipment connected.
The products is suitable for indoor and outdoor installation, continuous rated current is 630A (900A overload for 8 hours).
When the product is fitted with a suitable bushing or plug, a fully shielded and hermetically separable connection is provided. Long-term underwater and others
Harsh conditions of operation.
For cross-section of the cable cross-section of 25mm² ~ 400mm² XLPE cable

  • Executive standard
    EN 50181 Plug-in type bushings above 1kV up to 52kV and from 250A to 2.5kA for equipment other than liquid filled transformers
    EN 50180 Bushings above 1kV up to 36kV and from 250A to 3.15kA for liquid filled transformers
    HD629.1 Test requirements on accessories for used on power cables of rated voltage from 3.6/6(7.2)kV up to 20.8/36(42)kV-Part 1:cables with extruded insulation
    IEC 60502.4 Power cable with extruded insulation and their accessories for rated voltages from 1kV(U=1.2kV)up to 30kV(U=36kV)-part 4:test requirements on accessories for cable with rated voltages from 6kV up to 30kV(U=36kV)
    lEc60099 Metal oxide surge arresters without gaps for a.c.systems
    JB/T 8952 Polymer-housed metal oxide surge arresters without gaps for a.c.systems
    IEEE 386 Separable insulated connector system for power distribution system above 600V
    GB11032 Metal oxide surge arresters without gaps for a.c.system
    JB/T 8952 Polymer-housed metal oxide surge arresters without gaps for a.c.systems

Voltage characteristics

Current characteristics

Type description

Product structure
1、Bolt stud:adopt stainless steel bolts to ensure conductor and sleeve close fit.
2、Insulating layer: special formula and mixing technology to ensure high quality of prefabricated silicone rubber
3、Internal semi conductive layer: prefabricated inner semi conductive layer to effectively control the stress of electric field.
4、Outer semi conductive layer: The prefabricated outer semi conductive layer adheres closely to the insulating layer and ensures that the outer semi conductive layer is grounded.
5、Insulating plug:Epoxy resin insulating plug with threaded metal parts to ensure close cooperation with the stud.
6、Semi-conductive end cap:seal the end of the cable connector, so that the device has a full-screen, all-sealed function.
7、stress cone:Different size of the stress cone with the use of cable connectors, to ensure water seal and cable stress release.
8、Grounding hole: Pre-wired to the outer shield for ground wire connection.
9、Terminals: All copper or copper and aluminum crimp terminals for copper or aluminum conductor.
10、Positioning chain:Make sure the installation location is correct.

Parameter list